PRODUCT NEWS

Color Masterbatch Coloring Requirements



The color masterbatch has the following advantages: 1. Make the pigment have better dispersibility in the product. The color masterbatch must be refined during the production process to improve the dispersibility and coloring power of the pigment. The carrier of the special color masterbone is the same as the plastic of the product, has good matching, and is heated and melted. The post pigment particles are well dispersed in the product plastic. The color materials used for masterbatch must pay attention to the matching relationship between color materials and plastic raw materials and additives. The selection points are as follows.

(1) The coloring material cannot react with the resin and various auxiliary agents, and has strong solvent resistance, small mobility, and good heat resistance. That is to say, the masterbatch cannot participate in various chemical reactions. If carbon black can control the curing reaction of polyester plastic, carbon black can not be added to the polyester.

(2) The dispersibility and coloring power of the colorant should be good. When the color material is unevenly dispersed, it will affect the appearance performance of the product; when the coloring power of the color material is poor, the amount of color material will increase and the material cost will increase. The dispersibility and tinting strength of the same colorant in different resins are not the same, so you should pay attention to this when selecting the colorant.

The particle size of the colorant is also related to the dispersibility. The smaller the particle size, the better the dispersibility and the strong coloring power.

(3) It should be understood that other properties of colorants, such as plastic products used in food and children's toys, require that the colorants should be non-toxic; for plastic products used in electrical appliances, colorants with good electrical insulation should be selected; For outdoor plastic products, colorants with good weathering resistance should be selected.